After the cell winding is completed, the tabs on the cell need to be cut.
When welding the battery adapter, camera positioning is not used, and the consistency of the weld position is not good, which is easy to cause the size deviation of the welding seam of the battery welding,
In order to prevent the battery cell from scratching and leakage, it is necessary to wrap an insulating protective film on the surface of the battery cell.
When the sealing nail is welded, there is a deviation in the X and Y directions due to the liquid injection port and the nail position.
After the battery is stacked, the stacked batteries need to be welded together with two end plates and side plates to form a whole module
Use the area scan camera to detect the configuration on the syringe to ensure that the accessories on the syringe are not missing, and the front and back sides of the product are detected at the same time.
The device lights up the screen of the mobile phone, displays and switches red, green, blue, black, white, and gray images
Compatible with multiple product testing
Decoding accuracy reaches 99.9%
Before the electronic components are soldered on the PCB, the pin spacing and the flatness of the pins of the electronic components need to be detected to prevent the deformation of the pins of the electronic components from causing poor soldering of the components on the PCB.
Copyright © ShenZhen HuaZhou Measurement Control Co.Ltd. Record No:Guangdong ICP No. 14003909